Installation guide

Who Should Use This Guide
xiv About This Guide
Who Should Use This Guide
Thisguideisintendedforanetworkadministratorresponsibleforinstallingandsetting
uptheDFEmodule.
How to Use This Guide
ThisprefaceprovidesanoverviewofthisguideandtheDFE‐PlatinumSeriesmanualset,
abriefsummaryofeachchapter,anddefinestheconventionsusedinthisdocument.To
locateinformationaboutvarioussubjectsinthisguide,refertothefollowingtable:
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
For... Refer to...
An overview of the DFE module and instructions to
obtain technical support from Enterasys Networks
Chapter 1, Introduction
Network requirements that must be met before
installing the DFE module
Chapter 2, Network Requirements
Instructions to install the DFE module hardware
and optional interface card
Chapter 3, Installation
Troubleshooting installation problems and
diagnosing network/operational problems using the
LANVIEW LEDs
Chapter 4, Troubleshooting
Specifications, environmental requirements, and
physical properties of the DFE module and optional
Ethernet interface modules, and Mini-GBIC
interface cards
Appendix A, Specifications
Instructions to set the mode switches when
necessary and remove and replace the DRAM
SIMM or DIMM memory
Appendix B, Mode Switch Settings and
Installing Options