Installation guide

Setting Up the Chassis
Chassis Setup 3-7
d. Secure the power supply to the chassis by using a screwdriver to tighten the two slotted
screws on the front panel of the power supply. For proper chassis grounding, the screws
must be properly tightened.
5. If you are installing a second power supply, pull open the two latches on the blank plate over slot
PS2 until the plate is released. Remove the blank plate from the second power supply slot (keep
the blank plate in the event you need to remove the power supply), and repeat steps 1– 4.
Figure 3-4 Installing the Power Supply Module(s)
1 7C203-1 power supply 3 Module metal guide 5 7C103 chassis
2 Power supply handle 4 Chassis metal guide 6 Captive screws
NOTE: To install the modules, refer to the module installation guide for the installation
instructions. Before you power up the chassis, it is recommended that you complete the
installation of the modules in the chassis.
FAN
STATUS
7C203-1
REDUNDANCY
PWR
100-125V~12.0A
200-240V~6.0A
50/60 Hz
0
7C203-1
REDUNDANCY
PWR
100-125V~12.0A
200-240V~6.0A
50/60 Hz
0
Ä
Å Á À Å
Ã
Â