Installation guide

Setting Up the Chassis

Chassis Setup 3-3

To install the rubber feet, refer to Figure 3-1 and proceed as follows:

1. Place the chassis on its back on a sturdy flat surface to access the bottom of the chassis.

2. Remove the four rubber foot/screw assemblies from their plastic bag in the shipping box.

3. Locate the four tapped holes in the four corners on the bottom of the chassis.

Figure 3-1 Chassis Bottom, Rubber Feet Placement

4. Screw, by hand, each of the rubber foot/screw assemblies into the four tapped holes. Then,

tighten the rubber foot/screw assemblies with a Phillips screwdriver.

5. After installing the rubber feet, return the chassis to its upright position. Proceed to Section 3.2.4

and Section 3.2.5 for instructions to connect the Electrostatic Discharge (ESD) wrist strap and

install the power supply modules, respectively.

1 Bottom of chassis 2 Tapped hole for rubber foot (four locations)