Setup guide

3-1

Matrix E7 Setup

This chapter contains instructions on setting up the Matrix E7 chassis.

Equipment needed:

• Phillips screwdriver

• Flat blade screwdriver

A Phillips screwdriver is needed to install the unit in a 48.26-centimeter (19-inch) equipment rack

and to install the cable management bar. A large flat blade screwdriver is needed to secure the

power supplies and to remove and reinstall the fan tray. Refer to Chapter 2 for the guidelines that

must be followed to install the Matrix E7 chassis.

ELECTRICAL HAZARD: Only qualified personnel should install or service this unit.