Installation guide

Unpacking the Module
3-2 Installation
3.1 UNPACKING THE MODULE
Unpack the module as follows:
1. Open the box and remove the packing material protecting the module.
2. Verify the contents of the carton as listed in Table 3-1.
3. Remove the tape seal on the non-conductive bag to remove the module.
4. Perform a visual inspection of the module for any signs of physical damage. Contact Enterasys
Networks if there are any signs of damage. Refer to “Getting Help” for details.
3.2 INSTALLING OPTIONS INTO THE 6G306-06
You may install any optional GPIM into the 6G306-06 before proceeding to Section 3.3. GPIMs
may be installed before or after the module is installed into the chassis, as they are hot-swappable.
If you install the module before installing GPIMs, return to this section to install GPIMs in the
module, as improper installation can result in damage to either the GPIM or the module.
There are two different physical styles of GPIMs that can be installed into the module, as seen in
Figure 3-1. One style has the squeeze latch side clips (Figure 3-1, View A), with the procedure in
Section 3.2.1. The other style is the locking bar (Figure 3-1, View B), with the procedure in
Section 3.2.2.
Table 3-1 Contents of the Module Carton
Item Quantity
6G302-06 or 6G306-06 1
Antistatic Wrist Strap 1
Manual Accessory Kit 1
NOTE: If you are installing a 6G302-06, proceed to Section 3.3. Otherwise, proceed to
Section 3.2 for instructions on installing various options into the 6G306-06.
NOTE: If the module is to be installed with an optional FLASH upgrade, refer to
Appendix B before installing the module into the chassis.