Installation guide

Memory Locations and Replacement Procedures
B-6 Mode Switch Settings and Installing Options
Figure B-8 Removing the Existing DRAM SIMM
Installing the DRAM SIMM
ToinstallaDRAMSIMM,refertoFigure B‐9andproceedasfollows:
1. PushtheconnectorarmsawayfromtheDRAMSIMMenoughtoinserttheDRAMSIMMinto
theconnectorcontacts.
2. InserttheDRAMSIMMstraightdownbetweentheconnectorcontactsenoughforthetabson
theconnectorarmstoalign
withthetwoDRAMSIMMalignmentnotches.
3. PushtheDRAMSIMMdownintotheconnectorcontacts.Thenrotatethetwoconnectorarms
towardtheDRAMSIMMtolockitintoplace.
1 Connector arms 2 DRAM SIMM 3 Connector contacts
Â
Á
À
À
Caution: Observe all antistatic precautions when handling sensitive electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.