Installation guide

Using LANVIEW
Matrix DFE-Diamond Series Installation Guide 4-3
CPU None Power off. Ensure chassis has adequate power.
Amber Blinking. Module in process
of booting.
None.
Solid. Testing. If the LED remains amber for several minutes,
contact Enterasys Networks for technical
support.
Green Blinking. Image starts
running.
None.
Solid. Functional. None.
Red Solid. Processor in reset. None.
Green
and
Amber
Blinking. Indicates that the
DFE module is in the
process of shutting down.
None. This state is activated when the RESET
button is pressed for less than 1 second to a
start the process of an orderly shutdown.
While in this state, do not remove any DFE
module.
Amber
and off
Alternate (67% on, 33%
off). Indicates that a
shutdown process has
completed. This indication
will remain for 60 seconds
before automatically
restarting.
While in this state, you have 60 seconds to
safely remove the DFE module from the
chassis.
RX
(Receive)
None No link. No activity. Port
enabled or disabled.
None.
Green Solid. Link present, port
enabled, no traffic is being
received by the interface.
None.
Amber Flashing. Link present, port
enabled, traffic is being
received by the interface.
None.
RX Red Blinking. Indicates
collisions. This indication is
only supported on 10/100
ports.
Contact Enterasys Networks for technical
support.
TX
(Transmit)
None Port enabled, but no activity. If it is known that the port should be active and is
not, contact Enterasys Networks for technical
support.
Green Flashing. Indicates data
transmission activity. Rate
of flashing indicates the data
rate.
None.
Red Flashing. Fault or Error
(collision).
None, unless there is a high rate of activity. In
this case, check for network configuration
problems or a defective device.
Table 4-1 LANVIEW LEDs (continued)
LED Color State Recommended Action