Installation guide

Using LANVIEW
4-2 Troubleshooting
Figure 4-1 LANVIEW LEDs
Table 4‐1describestheLEDindicationsandprovidesrecommendedactionsasappropriate.
1 MGMT LED 2 Group 1, Port 1 LEDs
Note: The terms flashing, blinking, and solid used in Table 4-1 indicate the following:
Flashing indicates an LED is flashing randomly.
Blinking indicates an LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid indicates a steady LED light. No pulsing.
Alternate indicates an LED is flashing in a steady rate other than 50% on, 50% off.
Table 4-1 LANVIEW LEDs
LED Color State Recommended Action
MGMT None Off. This module is NOT the
Management Module.
None.
Green Solid. This module is the
designated Management
Module.
None.
Amber Flashing. This is a
temporary indication that the
module is saving data.
None.
7GR4280-19