Installation guide

Connecting to the Network

Matrix DFE-Diamond Series Installation Guide 3-19

Figure 3-14 Cable Connection to LC Fiber-Optic Connectors

3. VerifythatalinkexistsbycheckingthattheportRXLEDison(flashingamber,blinking

green,orsolidgreen).IftheRXLEDisoff,performthefollowingstepsuntilitison:

a. VerifythatthedeviceattheotherendofthesegmentisONandconnectedto

thesegment.

b. Ifthereareseparatefiber‐opticconnectionsontheotherdevice,checkthecrossoverofthe

cables.Swapthecableconnectionsifnecessary.

c. Checkthatthefiber‐opticconnectionmeetsthedBlossandcablespecificationsoutlined

intheCablingGuideformultimodefiber‐opticcabling.Toobtainthis

document,referto

“RelatedDocuments”inAboutThisGuide.

Ifalinkhasnotbeenestablished,refertoChapter 4forLEDtroubleshootingdetails.Ifa

problempersists,referto“GettingHelp”onpage xvfordetailsoncontacting

Enterasys Networksforsupport.

4. Repeatsteps1through3,above,untilallconnections

havebeenmade.

1 Installed Mini-GBIC LC connector 4 Receive LED (RX)

2 LC cable connector 5 Transmit LED (TX)

3 Release tab

7GR4270-12