Installation guide

Installing Optional Mini-GBICs

Matrix DFE-Diamond Series Installation Guide 3-5

Figure 3-3 Mini-GBIC with RJ45 Connector

Removing the Mini-GBIC

ToremoveaMini‐GBICfroma portslot,proceedasfollows:

1. Attachtheantistaticwriststrap(refertotheinstructionsintheantistaticwriststrappackage)

beforeremovingtheMini‐GBIC.

2. RemovethecablesconnectedtotheMini‐GBIC.

3. ReleasetheMini‐GBICfromtheportslot.Referbacktothe

appropriatefigurelistedbelowto

locatethereleasemechanismandproceedasinstructed.

–ForthetypeofMini‐GBICshowninFigure 3‐1,pushinonthereleasetabasfarasitwill

gotoreleasetheMini‐GBIC.

–ForthetypeofMini‐GBICshowninFigure 3‐2

,pulloutonthereleasetabtoreleasethe

Mini‐GBIC.

–ForthetypeofMini‐GBICshowninFigure 3‐3,pulldownonthewirehandletorelease

theMini‐GBIC.

4. GraspthesidesoftheMini‐GBICandpullitstraightoutoftheportslot.

Ifstoring

orshippingtheMini‐GBIC,insertitsdustprotectortoprotectitsfiber‐opticports.

1 Mini-GBIC (MGBIC-02) 4 Port slot

2 Mini-GBIC, top side 5 Wire-handle release

3 7-Pin edge connector (insertion side)

Caution: Do NOT remove a Mini-GBIC from a slot without releasing the locking tab located under

the front bottom end of the Mini-GBIC. This can damage the Mini-GBIC.

The Mini-GBIC and its host device are sensitive to static discharges. Use an antistatic wrist strap

and observe all static precautions during this procedure. Failure to do so could result in damaging

the Mini-GBIC or host device. Always leave the Mini-GBIC in the antistatic bag or an equivalent

antistatic container when not installed.

Precaución: NO quite el Mini- GBIC de la ranura sin antes abrir la traba ubicada en la parte

frontal del Mini- GBIC.

Si lo hace, puede dañar el Mini- GBIC, puesto que es muy sensible a las descargas de

electricidad estática, al igual que el dispositivo host. Utilice la pulsera antiestática y tome todas las

precauciones necesarias durante este procedimiento. Si no lo hace, pude dañar el Mini- GBIC o

el dispositivo host. Mientras no esté instalado, mantenga el Mini- GBIC en su bolsa antiestática o

en cualquier otro recipiente antiestático.