Installation guide

Matrix DFE-Diamond Series Installation Guide 3-1
3
Installation
Thischapterprovidestheinstructionstoinstallthe7GR4270‐12,7GR4202‐30,7GR4280‐19,and
7KR4290‐02DFEmodules,andoptionalMini‐GBICsandXENPAKinterfacemodules.
FollowtheorderofthesectionslistedbelowtocorrectlyinstalltheDFEmodule.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
Important Notice
Read the Release Notes shipped with the DFE module to check for any exceptions to the supported features
and operation documented in this guide.
Note: Unless otherwise noted, the installation instructions for the DFE modules apply to all DFE
modules.
For information about... Refer to page...
Required Tools 3-2
Unpacking the DFE Module 3-2
Installing Optional Network Expansion Modules (NEMs) 3-2
Installing Optional Mini-GBICs 3-3
Installing an Optional XENPAK Module 3-6
Backplane Connections and Installation Rules 3-8
Installing Module into Matrix E7 or N7 Chassis 3-10
Installing Module into Matrix N3, N1, or N5 Chassis 3-12
Connecting to the Network 3-13
Connecting to COM Port for Local Management 3-20
Completing the Installation 3-24