Installation guide

Matrix DFE-Diamond Series Installation Guide xiii
About This Guide
Thisguideprovidesanoverview,installationandtroubleshootinginstructions,andspecifications
fortheEnterasysMatrix
™
DFE‐Diamond 7GR4270‐12,7GR4202‐30,7GR4280‐19,and7KR4290‐02
modules,Mini‐GBICinterfacecards,andXENPAKinterfacemodules.
ForinformationabouttheCLI(CommandLineInterface)setofcommandsusedtoconfigureand
managetheDFEmodules,refertotheEnterasysMatrixDFE‐Diamond/PlatinumSeriesConfiguration
Guide.
Who Should Use This Guide
Thisguideisintendedforanetworkadministratorresponsiblefor installingandsettingupthe
DFEmodules.
Note: In this guide, the following terms are used:
• DFE refers to Distributed Forwarding Engine series of modules.
• DFE module or module refers to the 7GR4270-12, 7GR4202-30, 7GR4280-19, or
7KR4290-02. If the information applies only to one of the modules, the module is referred to by
its model number (such as 7GR4270-12).
• Network expansion module or NEM refers to an optional uplink card installed on the main logic
board and accessible through the option slot of the 7GR4280-19.
• Mini-GBIC (Mini-Gigabit Interface Card) refers to a smaller optional interface card that plugs
into a NEM or the 7GR4270-12 or 7GR4280-19 port slots.
• XENPAK PHY refers to a type of physical interface module that plugs into the 7KR4290-02.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.