Specifications

General Configuration Command Set
Downloading a Firmware Image
3-52 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.3.1 Downloading via the Serial Port
A serial download is the easiest method to upgrade the device firmware, requiring the least amount
of equipment and configuration.
To download device firmware via the serial (console) port, proceed as follows:
1. With the console port connected, reset the device by powering the device off and then on.
2. As the device is booting up, a message displays indicating POST Version, followed by “Starting
application”. At this point, reset the device again.
3. When the Power On Self Test (POST) begins, press ESC to bypass it. The following message
displays:
4. Press D to download system firmware. The following message displays:
5. Press 1 to download the agent firmware. The following messages display:
6. Change your terminal baud rate to 115200 bps and press ENTER.
7. Send the file using the XMODEM protocol from your computer application (the procedure
varies depending upon the application used).
8. When the XMODEM procedure finishes, the following messages display:
(D)ownload System Image or (S)tart Application: [S]
Select the Firmware Type to Download (1)Runtime (2)POST [1]:
(D)ownload System Image or (S)tart Application:
[S]
Select the Firmware Type to Download (1)Runtime (2)POST [1]:
Your Selection: Runtime Code
Download code to FlashROM address 0xff200000
Change Baud Rate to 115200 and Press <ENTER> to Download.
Verifying image in DRAM download buffer 0x01000000... SUCCESS !
Update FlashROM Image at 0xFF200000 ...
Erasing 3 FlashROM Blocks at 0xFF200000 ...
Writing FlashROM Image at 0xFF200000 ... SUCCESS !
Erasing 3 FlashROM Blocks at 0xFF500000 ...
Writing FlashROM Image at 0xFF500000 ... SUCCESS !
Change Baud Rate to 9600 and Press <ENTER>.