Specifications

VRRP create
session
Router Creates a VRRP session. For details, refer to Section 13.1.5.2.
create vlan vlan_id vrid
VRRP critical IP
Router Sets a critical IP address for VRRP routing. This defines an
interface — in addition to the interface between hosts and a
first-hop router — that will prevent the master router from
functioning properly if it were to fail. For details, refer to
Section 13.1.5.6.
critical-ip vlan vlan_id vrid ip_address
VRRP enable
Router Enables or disables VRRP on an interface. For details, refer to
Section 13.1.5.8.
enable vlan vlan_id vrid
VRRP preempt
mode
Router Enables or disables preempt mode on a VRRP router. Preempt is
enabled on VRRP routers by default, which allows a higher priority
backup router to preempt a lower priority master. For details, refer
to Section 13.1.5.7.
preempt vlan_id vrid
VRRP priority
Router Sets a priority value for a VRRP router. For details, refer to
Section 13.1.5.4.
priority vlan vlan_id vrid priority_value
wait
Switch Pauses the CLI for a specified number of seconds before executing
the next command. For details, refer to Section 3.2.7.1.
wait seconds
WebView (port,
set)
Switch Sets a different TCP port through which to run WebView. For
details, refer to Section 3.1.4.
set webview port webview_port
CLI Task Mode Command Function and Syntax