Specifications

CLI Tasks, Command Functions and Syntax
UDP (enable)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide A-57
traffic (show IP)
Router Displays general IP traffic statistics. For details, refer to
Section 12.2.5.2.
show ip traffic [softpath]
trunk (clear)
Switch Deletes a trunk from the switch. For details, refer to Section 4.4.3.4.
clear trunk [trunk_name]
trunk (set)
Switch Creates, enables or disables trunks on the switch. For details, refer
to Section 4.4.3.3.
set trunk trunk_name {create | disable | enable}
trunk (show)
Switch Displays trunking information for the switch. For details, refer to
Section .
show trunk [trunk_name]
trunk algorithm
(set)
Switch Sets the algorithm that will be used to distribute MAC addresses
across a trunk group. For details, refer to Section 4.4.3.7.
set trunk algorithm {machashing | roundrobin}
trunk mode
(set)
Switch Sets the trunking mode on the device. For details, refer to
Section 4.4.3.2.
set trunkmode {8023ad | porttrunking}
trunk port
(clear)
Switch Removes a port from a trunk. For details, refer to Section 4.4.3.6.
clear trunk port trunk_name port-string
trunk port (set)
Switch Adds one or more trunk ports to an existing trunk. For details, refer
to Section 4.4.3.5.
set trunk port trunk_name port-string
UDP (enable)
Router Enables or disables the forwarding of UDP datagrams and specifies
the new destination address. For details, refer to Section 12.2.4.2.
ip helper-address address
CLI Task Mode Command Function and Syntax