Specifications

CLI Tasks, Command Functions and Syntax
terminal (set)
A-56 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
terminal (set)
Switch Sets the number of columns and rows for the display terminal
connected to the device’s console port. This information is used to
control the output of the CLI itself. For details, refer to
Section 3.2.2.14.
set terminal {rows num-rows [disable] | cols num-cols} [static]
terminal (show)
Switch Displays the number of columns and rows for the terminal
connected to the device’s console. For details, refer to
Section 3.2.2.13.
show terminal
time (set)
Switch Changes the time of day on the system clock. For details, refer to
Section 3.2.2.4.
set time [day_of_week][mm/dd/yyyy][hh:mm:ss]
time (show)
Switch Displays the current time of day in the system clock. For details,
refer to Section 3.2.2.3.
show time
timeout (set
system)
Switch Sets the time (in minutes) an idle console or Telnet CLI session will
remain connected before timing out. For details, refer to
Section 3.2.2.15.
set system timeout timeout [console | remote]
traceroute
Switch Displays a hop-by-hop path through an IP network from the device
to a specific destination host when operating in switch mode. For
details, refer to Section 11.2.3.20.
traceroute [-w waittime] [-f first-ttl] [-m max-ttl] [-p port] [-q
nqueries] [-s src-addr] [-r] [-d] [-t tos] [-F] [-g gateway] [-I]
[-n] [-v] [-x] host [packetlen]
Router Displays a hop-by-hop path through an IP network from the device
to a specific destination host when operating in router mode. For
details, refer to Section 12.2.5.8.
traceroute host
CLI Task Mode Command Function and Syntax