Specifications

CLI Tasks, Command Functions and Syntax
config (set boot)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide A-5
CDP interval
(set)
Switch Sets the message interval frequency of the CDP discovery protocol.
For details, refer to Section 3.2.6.3.
set cdp interval frequency
config file
(show)
Switch Displays the contents of the CLI text configuration file. For details,
refer to Section 3.2.5.2.
show config [filename] {all | system}
config file
(execute)
Switch Executes, a previously downloaded configuration file, schedules
execution for a later time, cancels a scheduled execution, or displays
an execution schedule. For details, refer to Section 3.2.5.3.
configure {[filename [append] [at time] [in time] [reason
reason] | show | cancel}
config summary
(show/write)
Switch Displays the Matrix E1 non-default configuration to the console, or
writes the configuration to the swfile.cfg file. For details, refer to
Section 3.2.5.4.
summaryconfig [file]
config file
(copy)
Switch Uploads or downloads a flash configuration or text configuration
(CLI command) file. For details, refer to Section 3.2.5.5.
copy source destination
config file
(delete)
Switch Removes a configuration file from the Matrix E1 system. For
details, refer to Section 3.2.5.7.
delete filename
config (save
running)
Router Saves or deletes the router running configuration, or displays it to
output devices. For details, refer to Section 12.2.2.2.
write [erase | file [filename config_file] | terminal]
config (set
boot)
Switch Selects the configuration file the device will load at startup. For
details, refer to Section 3.2.5.6.
set system bootconfig {flash | network file-location}
CLI Task Mode Command Function and Syntax