Specifications

Security Configuration Command Set
Configuring Access Lists
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-101
14.3.7.2 access-list (standard)
Use this command to define a standard IP access list by number when operating in router mode.
Restrictions defined by an access list are applied by using the
ip access-group command
(Section 14.3.7.4).
access-list access-list-number [insert | replace entry] | [move destination source1
[source2]] {deny | permit} source [source-wildcard]
To insert or replace an ACL entry:
access-list access-list-number insert | replace entry
To move entries within an ACL:
access-list access-list-number move destination source1 [source2]
Syntax Description
ROUTER: This command can be executed when the device is in router mode only. For
details on how to enable router configuration modes, refer to Section 3.3.3.
NOTE: Valid access-list-numbers for standard ACLs are 1 to 99. For extended ACLs,
valid values are 100 to 199.
access-list-
number
Specifies a standard access list number. Valid values are
from 1 to 99.
insert | replace
entry
(Optional) Inserts this new entry before a specified entry in
an existing ACL, or replaces a specified entry with this new
entry.
move destination
source1 source2
(Optional) Moves a sequence of access list entries before
another entry. Destination is the number of the existing entry
before which this new entry will be moved. Source1 is a
single entry number or the first entry number in the range to
be moved. Source2 (optional) is the last entry number in the
range to be moved. If not specified, only the source1 entry
will be moved.
deny | permit Denies or permits access if specified conditions are met.