Specifications

Startup and General Configuration Summary
Starting and Navigating the Command Line Interface (CLI)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-11
7. Configuring CDP (Section 3.2.6)
8. Pausing, clearing and closing the CLI (Section 3.2.7)
9. Resetting the device (Section 3.2.8)
10. Preparing the device for router mode (Section 3.3)
3.1.6 Starting and Navigating the Command Line Interface (CLI)
3.1.6.1 Using a Console Port Connection
Once you have connected a terminal to the local console port as described in Chapter 2, the initial
startup screen, Figure 3-2, will display. You can now start the Command Line Interface (CLI) by
• Using a default user account, as described in Section 3.1.6.2, or
• Using an administratively-assigned user account as described in Section 3.1.6.3.
3.1.6.2 Logging in with a Default User Account
If this is the first time your are logging in to the Matrix E1 Series device, or if the default user
accounts have not been administratively changed, proceed as follows:
1. At the Username login prompt, enter one of the following default user names:
• ro for Read-Only access,
• rw for Read-Write access.
• admin for Super User access.
2. Press ENTER. The Password prompt displays.
NOTE: By default, the Matrix E1 Series device is configured with three user login
accounts: ro for Read-Only access; rw for Read-Write access; and admin for
super-user access to all modifiable parameters. The default password is set to a blank
string (carriage return). For information on changing these default settings, refer to
Section 3.2.1.