Specifications

VLAN Configuration Command Set
Assigning Port VLAN IDs (PVIDs) and Ingress Filtering
7-16 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
7.3.3.2 set port vlan
Use this command to configure the PVID (port VLAN identifier) for one or more ports.
set port vlan port-string vlan-id
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to add Fast Ethernet front panel port 10 to the port VLAN list of VLAN
4 (PVID 4). It also shows how port fe.0.10 is added to that VLAN’s untagged egress list:
NOTE: The PVID is used to classify untagged frames as they ingress into a given port.
When setting a PVID with the set port vlan command, you can also add the port to the
VLAN’s untagged egress list.
port-string Specifies the port(s) for which to configure a VLAN
identifier. For a detailed description of possible port-string
values, refer to Section 4.1.2.
vlan-id Specifies the VLAN to which port(s) will be added.
Matrix>set port vlan fe.0.10 4
The PVID is used to classify untagged frames as they
ingress into a given port. Would you like to add the selected
port(s) to this vlan's untagged egress list and remove them
from all other vlans untagged egress list(y/n) [n]?
NOTE: choosing 'y' will not remove the port(s) from previously
configured tagged egress lists
.y
Matrix>clear vlan egress 1 fe.0.10
Matrix>
Matrix>set vlan egress 4 fe.0.10 untagged