Specifications

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
6-30 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
6.2.1.22 clear spantree hello
Use this command to reset the bridge hello time for the bridge or for one or more ports to the
default value of 2 seconds.
clear spantree hello [port-string]
Syntax Description
Command Defaults
If bridge mode is disabled, a port-string is required to reset all ports. For
information on using the set spantree bridgehellomode command, refer to
Section 6.2.1.19.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the bridge hello time to 2 seconds:
port-string (Optional) Resets the hello time for specific port(s).
NOTE: Port-string cannot be specified if bridge
hello mode is enabled. For information on using the
set spantree bridgehellomode command, refer to
Section 6.2.1.19.
Matrix>clear spantree hello