Specifications

SNMP Command Set
Configuring SNMP Notification Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-57
5.2.7.2 set trap
Use this command to configure an SNMP trap assigned to an IP address. Since the device is an
SNMP compliant device, it can send messages to multiple network management stations to alert
users of status changes. For details on the types of traps this device supports, refer to the appropriate
Matrix E1 Release Notes.
set trap ip_ address community_name {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable a trap on IP address 172.29.65.123 in the “blue” community:
ip_address Specifies the IP address of the trap to be set.
community_name Specifies the community name of the trap to be set.
enable | disable Enables or disables the trap.
Matrix>set trap 172.29.65.123 blue enable