Specifications

SNMP Command Set
Configuring SNMP Target Addresses
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-53
Command Defaults
• If not specified, udpport will be set to 162.
• If not specified, timeout will be set to 1500 seconds.
• If not specified, number of retries will be set to 3.
• If not specified, storage type will be nonvolatile.
• If taglist is not specified, none will be set.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set an SNMP target address of “1” associated with a parameter called
v1ExampleParams on IP address 127.0.0.1 and UDP port 160:
Matrix>set snmp targetaddr 1 param v1ExampleParams ipaddr 127.0.0.1 udp 160