Specifications

SNMP Command Set
Configuring SNMP Target Addresses
5-52 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
5.2.6.2 set snmp targetaddr
Use this command to set an SNMP target address configuration. The target address is a unique
identifier and a specific IP address that will receive SNMP notification messages. This address
configuration can be linked to optional SNMP transmit parameters (such as timeout, retry count,
and UDP port).
set snmp targetaddr targetaddr param param ipaddr ipaddr [port udpport]
[timeout timeout] [retries retries] [volatile | nonvolatile] [taglist tagname]
Syntax Description
targetaddr Specifies a unique identifier to index the
snmpTargetAddrTable. Maximum length is 32 bytes.
param param Specifies an entry in the SNMP target parameters table,
which is used when generating a message to the target.
Maximum length is 32 bytes.
ipaddr ipaddr Specifies the IP address of the target.
port udpport (Optional) Specifies which UDP port of the target host to
use. Default value is 162.
timeout timeout (Optional) Specifies the maximum round trip time
allowed to communicate to this target address. This value
is in .01 seconds and the default is 1500 (15 seconds.)
retries retries (Optional) Specifies the number of message retries
allowed if a response is not received. Default is 3.
volatile |
nonvolatile
(Optional) Specifies temporary (default), or nonvolatile
storage for SNMP entries.
taglist tagname (Optional) Specifies a list of SNMP notify tag values.
This tags a location to the target address as a place to send
notifications. List must be enclosed in quotes and tag
values must be separated by a space (ie: “tag 1 tag 2”)