Specifications

SNMP Command Set
Configuring SNMP Users, Groups and Communities
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-17
5.2.2.2 set snmp user
Use this command to create a new SNMPv3 user.
set snmp user user [authentication {md5 authpassword [privacy
privpassword]][remote remote] [{volatile | nonvolatile}]
Syntax Description
Command Defaults
• If authentication is not specified, no authentication will be applied.
• If authpassword is not specified, none will be applied.
• If privacy is not specified, no encryption will be applied.
• If remote is not specified, the user will be registered for the local SNMP
engine.
• If storage type is not specified, nonvolatile will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
user Specifies a name for the SNMPv3 user.
authentication md5 (Optional) Specifies the authentication type required for
this user as MD5.
authpassword (Optional) Specifies a password for this user when
authentication is required. Minimum of 8 characters.
privacy
privpassword
(Optional) Applies encryption and specifies an
encryption password. Minimum of 8 characters
remote remote (Optional) Registers the user on a specific remote SNMP
engine.
volatile |
nonvolatile
(Optional) Specifies a storage type for this user entry.