Specifications

Preparing the Device for Router Mode
Configuring VLANs for IP Routing
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-91
Example
The example in Figure 3-7 shows how to configure two VLANs for IP routing. VLAN 10 is set on
Fast Ethernet front panel port 1 with an IP address of 182.127.63.1, and VLAN 20 is set on Fast
Ethernet front panel port 2 with an IP address of 182.127.62.1. The configuration is then saved to
NVRAM in file called startup.cfg.
Step 9
Assign an IP address
to the VLAN.
ip address
{ip_address
ip_mask}
Router:
Matrix>
Router(config-if
(Vlan
<vlan_id>))#
Section 12.2.1.4
Step 10
Enable the VLAN
for IP routing.
no shutdown Router:
Matrix>
Router(config-if
(Vlan 1))#
Section 12.2.1.5
Step 11
Repeat steps 6 through 10 to configure additional VLAN(s) for IP routing.
Step 12
Save the routing
configuration to
NVRAM.
write file
filename
config_file
Router:
Matrix>Router#
Section 12.2.2.2
Table 3-7 Command Set for Configuring VLANs for IP Routing (Continued)
To do this task...
Type this
command...
In this mode...
For details,
see...