Specifications

Preparing the Device for Router Mode
Configuring VLANs for IP Routing
3-90 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Table 3-7 Command Set for Configuring VLANs for IP Routing
To do this task...
Type this
command...
In this mode...
For details,
see...
Step 1
Disable Spanning
Tree on the dedicated
routing port.
set spantree
portadmin
port-string
disable
Switch:
(Matrix>)
Section 6.2.2.2
Step 2
Create a new IEEE
802.1Q VLAN or
enable an existing
VLAN on the
dedicated routing
port.
set vlan {create |
enable} vlan_id
Switch:
(Matrix>)
Section 7.3.2.1
Step 3
Set the port’s VLAN
identifier (vlan_id).
Enter y when
prompted to add the
port to the VLAN’s
untagged egress list
and remove it from
all other VLANs’
untagged egress lists.
set port vlan
port-string
vlan_id
Switch:
(Matrix>)
Section 7.3.3.2
Step 4
Disable GVRP on
the dedicated routing
port.
set gvrp disable
port-string
Switch:
(Matrix>)
Section 7.3.8.3
Step 5
Repeat steps 1 through 4 to create additional VLAN(s).
Step 6
Enable router mode. router Switch:
(Matrix>)
Section 3.3.3
Step 7
Enable global router
configuration mode.
configure
terminal
Router:
Matrix>Router#
Section 3.3.3
Step 8
Enable interface
configuration mode.
interface vlan_id Router:
Matrix>
Router(config)#
Section 12.2.1.2