Specifications

General Configuration Command Set
Configuring Telnet
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-57
3.2.4.1 show telnet
Use this command to display Telnet status and information.
show telnet
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-only.
Example
This example shows how to display Telnet status and information. In this case inbound and
outbound service is enabled on the device and maximum number of inbound, outbound and SSH
Telnet sessions have not been changed from the default value of 4. For details on using the set telnet
command to change default settings, refer to Section 3.2.4.2:
Matrix>show telnet
Inbound telnet is currently enabled on port 23.
Outbound telnet is currently enabled.
Maximum inbound telnet sessions = 4.
Maximum outbound telnet sessions = 4.
Maximum ssh telnet sessions = 4.