User`s guide

Bridge Extension Configuration Screen
3-20 WebView Local Management Tasks
3.13 BRIDGE EXTENSION CONFIGURATION SCREEN
When to Use
To view bridge MIB extension capabilities configured on the device, and to set the host VLAN ID.
How to Access
Click on Bridge Extension on the WebView navigation frame. The Bridge Extension
Configuration screen, Figure 3-12, displays.
Priority Enter a bridge priority value for the port. This number represents the
cost of a link in the Spanning Tree bridge. Valid values are from 0 to
128, with 0 indicating high priority and 128, low priority.
Path Cost Enter a value (1 to 65535) to assign path cost to a port. This setting
takes precedence over Priority. The parameter entered here is used by
the STA to determine the best path between devices. Therefore, lower
values should be assigned to ports attached to faster media, and higher
values assigned to ports with slower media. The default and
recommended cost range is:
Ethernet: 100 (50-100)
Fast Ethernet: 10 (10-60)
Gigabit Ethernet: 1 (1-10)
Fast Forward Enable or disable fast forwarding mode on individual ports.
Table 3-11 STA Port Configuration Screen Element Descriptions (Continued)
Use this field… To…