User`s guide

Port Designations in WebView
2-6 Starting and Navigating WebView
2.6 PORT DESIGNATIONS IN WEBVIEW
The expansion module and fixed front panel port numbering scheme used when configuring
Matrix E1 ports is shown in Figure 2-3. Fixed front panel ports 1 through 48 are RJ45 10/100
Ethernet connections. In WebView screens with Port listings, these fixed front panel ports are
designated as 1 through 48.
The device’s optional expansion module slots (1, 2, and 3), can have two to 16 ports depending on
the module installed. Figure 2-4 shows the Ethernet Expansion Modules available at the time of
this printing, and the location of the next consecutive port on each module. Table 2-2 shows the
Mirror Go to the Mirror Port Configuration screen, where you can
enable port mirroring on the device and set a source and
target port for mirroring.
Trunk Go to the Port Trunking Configuration screen, where you
can add or remove trunks on the device, and add or remove
trunk ports from existing trunks.
Statistics Go to the Port Statistics screen, where you can view port
Ethernet-like MIB statistics and RMON statistics.
Console Go to the Console Configuration screen, where you can
configure device console settings, such as baud rate, time
out, and auto refresh rate.
Apply entries made to the WebView screen on display.
Clear entries made to the WebView screen on display.
Go to WebView online help for this Matrix E1 device.
Table 2-1 Screen Designations and Functions in the Navigation Frame (Continued)
Click on... To...