User`s guide

Navigating WebView
2-4 Starting and Navigating WebView
WebView online Help. Table 2-1 describes the screen links in the navigation frame and their
functions.
Table 2-1 Screen Designations and Functions in the Navigation Frame
Click on... To...
System Go to the System screen, where you can view and configure
system (device) settings, such as the name and location of
the device. Links on this screen also enable you to Telnet to
the textual Command Line Interface (CLI), to send email to
Enterasys technical support, and to connect to the Enterasys
Web page.
Switch Go to the Switch Information screen, where you can view
information about the main system board, including serial
number, number of ports, and hardware and firmware
versions.
IP Go to the IP Configuration screen, where you can set the
host IP state, IP address, subnet mask, gateway IP address,
and maximum number of Telnet sessions allowed, and view
the device’s MAC address.
SNMP Go to the SNMP Traps Configuration and SNMP
Community Names screens. Here you can assign IP
addresses where SNMP traps will be sent, enable or disable
traps, and set SNMP community names and access policies
associated with these traps.
Security Go to the Security Configuration screen, where you can set a
new login password for the device.
Upgrade Go to the TFTP Download Management screen, where you
can download a new firmware image from a TFTP server to
the device.
Address Table Go to the Address Table Configuration screen, where you
can view entries in the device’s address table, add new static
address entries, remove entries, and view counts of dynamic
and static addresses in the address table.