User`s guide

Using WebView with Matrix E1 Devices
1-2 Introduction
1.2 USING WEBVIEW WITH MATRIX E1 DEVICES
WebView is an intuitive tool for initial configuration and simple management tasks. It allows a
network manager to perform the following tasks:
• Assign a new IP address and subnet mask to the device.
• Select a default gateway.
• Assign a login password to the device for additional security.
• Download a new firmware image.
• Designate which network management workstations receive SNMP traps from the device.
• View device and RMON statistics.
• Enable ports to operate in standard or full duplex mode.
• Configure ports to perform load sharing using trunking commands.
• Set flow control on a port-by-port basis.
• Configure ports to prioritize incoming frames.
• Set 802.1Q VLAN memberships.
• View and configure basic Spanning Tree device and per-port settings.