Specifications

trunk algorithm
(set)
Switch Sets the algorithm that will be used to distribute MAC addresses
across a trunk group. For details, refer to Section 4.4.3.7.
set trunk algorithm {machashing | roundrobin}
trunk mode
(set)
Switch Sets the trunking mode on the device. For details, refer to
Section 4.4.3.2.
set trunkmode {8023ad | porttrunking}
trunk port
(clear)
Switch Removes a port from a trunk. For details, refer to Section 4.4.3.6.
clear trunk port trunk_name port-string
trunk port (set)
Switch Adds one or more trunk ports to an existing trunk. For details, refer
to Section 4.4.3.5.
set trunk port trunk_name port-string
UDP (enable)
Router Enables DHCP/BOOTP relay and the forwarding of local UDP
broadcasts specifying a new destination address. For details, refer to
Section 12.2.4.3.
ip helper-address address
UDP redirect
Router Enables UDP broadcast forwarding and specifies which protocols
will be forwarded. For details, refer to Section 12.2.4.2.
ip forward-protocol {udp [port]}
users (show)
Switch Displays information about the active console port or Telnet
session(s) logged in to the device. For details, refer to
Section 11.2.2.9.
show users
version (show)
Switch Displays firmware and hardware information. For details, refer to
Section 3.2.2.9.
show version
VLAN (clear)
Switch Removes a statically created VLAN from the list of VLANs
recognized by the device. For details, refer to Section 7.3.2.3.
clear vlan vlan-string
CLI Task Mode Command Function and Syntax