Specifications

CLI Tasks, Command Functions and Syntax
SNMP target parameters (set)
A-48 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
SNMP target
parameters (set)
Switch Sets the SNMP target parameters configuration. For details, refer
to Section 5.2.5.2.
set snmp targetparams paramsname user user security-model
{v1 | v2c | v3} message-processing {v1 | v2c | v3}
{noauthentication | authentication | privacy} [volatile |
nonvolatile]
SNMP target
parameters
(show)
Switch Displays SNMP target parameters. For details, refer to
Section 5.2.5.1.
show snmp targetparams [targetParams]
SNMP trap
(clear)
Switch Deletes an SNMP trap assigned to an IP address. For details, refer
to Section 5.2.7.3.
clear trap ip_address
SNMP trap (set)
Switch Assigns an SNMP trap to an IP address. For details, refer to
Section 5.2.7.2.
set trap ip_ address community_name {enable | disable}
SNMP trap
(show)
Switch Displays SNMP trap configuration information. For details, refer to
Section 5.2.7.3.
show trap
SNMP trap (set
port)
Switch Enables or disables ports for sending SNMP trap messages when
their link status changes. For details, refer to Section 4.2.7.2.
set port trap port-string {enable | disable}
SNMP trap
(show port)
Switch Displays the status of SNMP link trap messaging on one or more
ports. For details, refer to Section 4.2.7.1.
show port trap [port-string]
SNMP user
(clear)
Switch Removes a user from the SNMPv3 security-model list. For details,
refer to Section 5.2.2.3.
clear snmp user user [remote remote]
CLI Task Mode Command Function and Syntax