Specifications

CLI Tasks, Command Functions and Syntax
rate limit (set port)
A-40 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
rate limit (set
port)
Switch Sets the traffic rate limiting status and threshold (in bits per second)
for one or more ports. For details, refer to Section 9.3.6.2.
set port ratelimit {disable | enable port-string priority
threshold {discard | marked} {disable | enable} }
rate limit (show
port)
Switch Displays the current traffic rate limiting configuration on one or
more ports. For details, refer to Section 9.3.6.1.
show port ratelimit [port-string]
repeat
Switch Repeats a command listed in the command history buffer. For
details, refer to Section 11.2.2.4.
repeat [cmd_num] [iterations]
reset
Switch Resets the device immediately or cancels or displays information
about a scheduled reset. For details, refer to Section 3.2.8.2.
reset [system [cancel]] [show]
reset (at a
future time)
Switch Schedules a system reset at a specific future time. For details, refer
to Section 3.2.8.3.
reset at hh:mm [mm/dd] [reason reason]
reset (after a
specified time)
Switch Schedules a system reset after a specified time. For details, refer to
Section 3.2.8.4.
reset in hh:mm [reason reason]
RIP
authentication
key
Router Identifies a RIP authentication key on a key chain. For details, refer
to Section 13.1.1.10.
key key-id
RIP
authentication
accept lifetime
Router Specifies the time period during which a RIP authentication key on
a key chain is valid to be received. For details, refer to
Section 13.1.1.12.
accept-lifetime start-time month date year {duration seconds |
end-time | infinite}
CLI Task Mode Command Function and Syntax