Specifications

CLI Tasks, Command Functions and Syntax
OSPF authentication key
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide A-27
negotiation
(show port)
Switch Displays the status of auto-negotiation on one or more ports. For
details, refer to Section 4.2.5.1.
show port negotiation [port-string]
netstat (show)
Switch Displays statistics for the switch’s active network connections. For
details, refer to Section 11.2.2.7.
show netstat [icmp | interface | ip | routes | stats | tcp | udp]
NVRAM (clear)
Switch Clears the user-defined configuration parameters stored in
NVRAM. For details, refer to Section 3.2.8.5.
clear config
OSPF (show)
Router Displays OSPF information. For details, refer to Section 13.1.2.23.
show ip ospf
OSPF area
authentication
Router Enables or disables authentication for an OSPF area. For details,
refer to Section 13.1.2.15.
area area-id authentication {simple | message-digest}
OSPF area
default cost
Router Sets the cost value for the default route that is sent into a stub area
by an Area Border Router (ABR). For details, refer to
Section 13.1.2.17.
area area-id default-cost cost
OSPF area
range
Router Defines the range of addresses to be used by Area Border Routers
(ABRs) when they communicate routes to other areas. For details,
refer to Section 13.1.2.14.
area area-id range ip_address ip_mask
OSPF
authentication
key
Router Assigns a password to be used by neighboring routers using OSPF’s
simple password authentication. For details, refer to
Section 13.1.2.11.
ip ospf authentication-key password
CLI Task Mode Command Function and Syntax