Specifications

CLI Tasks, Command Functions and Syntax
logging server (show)
A-22 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
logging server
(show)
Switch Displays the Syslog configuration for a particular server. For
details, refer to Section 11.2.1.5.
show logging server [index]
MAC (set)
Switch Adds MAC addresses to the switch IP routing table. For details,
refer to Section 11.2.3.7.
set mac mac_address vlan_id port-string {delete-on-reset |
delete-on-timeout | permanent}
Router Sets a MAC address on a routing interface. For details, refer to
Section 12.2.3.4.
ip mac-address address
MAC (show)
Switch Displays MAC addresses contained in the switch’s routing table.
For details, refer to Section 11.2.3.6.
show mac [address mac address] [fid vlan_id] [port
port-string] [type {learned | self | mgmt}]
MAC address
(clear)
Switch Deletes dynamic MAC address information for the switch. For
details, refer to Section 11.2.3.8.
clear mac [address mac_address vlan-id | port port-string | vid
vlan-id port-string]
MAC address
traps (set)
Switch Enables or disables SNMP trap messaging, globally or on one or
more ports, when new source MAC addresses are detected. For
details, refer to Section 5.2.7.5.
set newaddrtrap [port-string] {enable | disable}
MAC address
traps (show)
Switch Displays the status of MAC address traps on one or more ports. For
details, refer to Section 5.2.7.4.
show newaddrtrap [port-string]
MAC aging time
(clear)
Switch Resets the MAC address aging timer to the default value of 300
seconds. For details, refer to Section 11.2.3.11.
clear mac agingtime
CLI Task Mode Command Function and Syntax