Specifications

CLI Tasks, Command Functions and Syntax
IRDP broadcasts (enable)
A-18 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
IRDP
broadcasts
(enable)
Router Enables the router to send IRDP advertisements using broadcast
rather than multicast transmissions. By default, the router sends
IRDP advertisements via multicast. For details, refer to
Section 13.1.4.7.
no ip irdp multicast
IRDP hold time
Router Sets the length of time in seconds IRDP advertisements are held
valid. For details, refer to Section 13.1.4.4.
ip irdp holdtime holdtime
IRDP maximum
advertisement
interval
Router Sets the maximum interval in seconds between IRDP
advertisements. For details, refer to Section 13.1.4.2.
ip irdp maxadvertinterval interval
IRDP minimum
advertisement
interval
Router Sets the minimum interval in seconds between IRDP
advertisements. For details, refer to Section 13.1.4.3.
ip irdp minadvertinterval interval
IRDP
preference
Router Set the IRDP preference value for an interface. This value is used by
IRDP to determine the interface’s selection as a default gateway
address. For details, refer to Section 13.1.4.5.
ip irdp preference preference
jumbo frame
support (set
port)
Switch Disables or re-enables jumbo frame support on one or more ports.
For details, refer to Section 4.2.4.2.
set port jumbo {disable | enable}
jumbo frame
support (show
port)
Switch Displays the status of jumbo frame support and maximum
transmission units (MTU) on one or more ports. For details, refer to
Section 4.2.4.1.
show port jumbo
limits (show)
Router Displays memory usage information about IP protocols running on
the device. For details, refer to Section 12.2.5.2.
show limits
CLI Task Mode Command Function and Syntax