Specifications

CLI Tasks, Command Functions and Syntax
IRDP address
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide A-17
IP interface
(enable)
Router Enables an interface for IP routing and allows it to automatically be
enabled at device startup. For details, refer to Section 12.2.1.5.
no shutdown
IP interface
(show)
Router Displays usability status and other information about interfaces
configured for IP routing. For details, refer to Section 12.2.1.3.
show ip interface [vlan vlan_id | loopback loopback-id]
IP route (set)
Router Adds or removes a static IP route. For details, refer to
Section 12.2.5.6.
ip route prefix mask {forward-addr |vlan vlan-id} [distance]
[permanent] [tag value]
IP route (show)
Router Displays information about IP routes. For details, refer to
Section 12.2.5.5.
show ip route [destination prefix destination prefix mask
longer-prefixes | connected | ospf | rip | static | summary]
IP traffic
statistics (clear)
Router Clears all IP traffic counters (IP, ICMP, UDP, TCP, IGMP and
ARP). For details, refer to Section 12.2.5.4.
clear ip stats
IRDP (enable)
Router Enables or disables IRDP on an interface. For details, refer to
Section 13.1.4.1.
ip irdp
IRDP (show)
Router Displays IRDP information. For details, refer to Section 13.1.4.8.
show ip irdp [vlan vlan_id]
IRDP address
Router Adds additional IP addresses for IRDP to advertise. For details,
refer to Section 13.1.4.6.
ip irdp address ip_address preference
CLI Task Mode Command Function and Syntax