Specifications

CLI Tasks, Command Functions and Syntax
EAPOL (show)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide A-11
dot1x
authentication
configuration
(show port)
Switch Displays 802.1X authentication configuration settings for one or
more ports. For details refer to Section 14.3.2.2.
show dot1x auth-config [authcontrolled-portcontrol]
[keytxenabled] [maxreq] [quietperiod] [reauthenabled]
[reauthperiod] [servertimeout] [supptimeout] [txperiod]
[port-string]
download
Switch Downloads a new firmware image to the device from a TFTP server.
For details refer to Section 3.2.3.2.
dload hostname | ip_address filename [noreboot]
duplex (set
port)
Switch Sets the default duplex setting (half or full duplex) of one or more
ports. For details, refer to Section 4.2.3.2.
set port duplex port-string {full | half}
DVMRP (enable)
Router Enables or disables the Distance Vector Multicast Routing Protocol
(DVMRP) on an interface. For details, refer to Section 13.1.3.1.
ip dvmrp
DVMRP metric
(set)
Router Configures the metric associated with destinations for DVMRP
reports. For details, refer to Section 13.1.3.2.
ip dvmrp metric metric
DVMRP route
(show)
Router Displays the status of DVMRP (enabled or disabled) and entries in
the DVMRP routing table. For details, refer to Section 13.1.3.3.
show ip dvmrp route
EAPOL (set)
Switch Enables or disables EAPOL port-based user authentication with the
RADIUS server, and sets the authentication mode for one or more
ports. For details, refer to Section 14.3.2.8.
set eapol [enable | disable | auth-mode {auto |
forced-authorized | forced-unauthorized} port-string
EAPOL (show)
Switch Displays EAPOL settings for one or more ports. For details, refer to
Section 14.3.2.7.
show eapol [port-string]
CLI Task Mode Command Function and Syntax