Specifications

CLI Tasks, Command Functions and Syntax
convergence end points detection type (set)
A-8 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
convergence
end points
detection type
(set)
Switch Sets the convergence end points detection phone type as H.323 or
Siemens. For details, refer to Section 11.2.6.6.
set cep detection detection-id type {h323 | siemens}
convergence
end points
detection group
(create)
Switch Creates a new H.323 or Siemens convergence end points detection
configuration group, or enables, disables or removes an existing
group. For details, refer to Section 11.2.6.5.
set cep detection detection-id {create | delete | disable |
enable}
convergence
end points
detection policy
(set)
Switch Sets a global default policy for a CEP detection type. This is the
policy that will be applied when a phone of the specified type is
detected on a port. For details, refer to Section 11.2.6.4.
set cep policy {cisco | h323 | siemens} profile-id
convergence
end points
detection
re-initialize
Switch Re-initializes convergence end points detection on one or more
CEP-enabled ports. For details, refer to Section 11.2.6.10.
set cep initialize port-string
convergence
end points
detection ports
(set)
Switch Sets the maximum and minimum UDP / TCP ports used for an
H.323 or Siemens convergence end points detection. For details,
refer to Section 11.2.6.9.
set cep detection detection-id {porthigh | portlow port}
convergence
end points
detection
protocol (set)
Switch Specifies an IP protocol type for H.323 or Siemens convergence
end points detection. For details, refer to Section 11.2.6.8.
set cep detection detection-id protocol {tcp | udp | both |
none}
counters (show
port)
Switch Displays counter statistics detailing traffic through the switch and
through all MIB2 network devices. For details, refer to
Section 4.2.1.2.
show port counters [port-string] [mib2 | switch]
CLI Task Mode Command Function and Syntax