Specifications

CLI Tasks, Command Functions and Syntax
convergence end points detection port (enable)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide A-7
config (set
boot)
Switch Selects the configuration file the device will load at startup. For
details, refer to Section 3.2.5.6.
set system bootconfig {flash | network file-location}
config (show
running)
Router Displays the current non-default router operating configuration. For
details, refer to Section 12.2.2.1.
show running-config
counters (clear
port)
Switch Clears port counter statistics for one or more ports. For details, refer
to Section 4.2.1.3.
clear port counters [port-string]
convergence
end points
detection (clear)
Switch Clears CEP detection parameters. For details, refer to
Section 11.2.6.11.
clear cep {[all | policy | detection] [port port-string {all | cisco
| h323 | siemens}]}
convergence
end points
detection
(enable)
Switch Globally enables or disables convergence end points detection. For
details, refer to Section 11.2.6.2.
set cep {enable | disable}
convergence
end points
detection
(show)
Switch Displays convergence end points settings. For details, refer to
Section 11.2.6.1.
show cep [connections] [detection] [policy] [[port]
[port-string]]
convergence
end points
detection
address (set)
Switch Sets an H.323 or Siemens convergence end points detection group
IP address or mask. For details, refer to Section 11.2.6.7.
set cep detection detection-id {[address {ipv4 ip-address |
unknown}] [mask {ipv4 mask | unknown}]}
convergence
end points
detection port
(enable)
Switch Enables or disables a convergence end points detection type on one
or more ports. For details, refer to Section 11.2.6.3.
set cep port port-string {cisco | h323 | siemens} {enable |
disable}
CLI Task Mode Command Function and Syntax