Specifications

Security Configuration Command Set
Configuring Access Lists
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-103
Command Syntax of the “no” Form
The “no” form of this command removes the defined access list or entry:
no access-list access-list-number [entry]
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router(config)#
Command Defaults
• If insert, replace or move are not specified, the new entry will be appended to
the access list.
• If source2 is not specified with move, only one entry will be moved.
move destination
source1 source2
(Optional) Moves a sequence of access list entries before
another entry. Destination is the number of the existing entry
before which this new entry will be moved. Source1 is a
single entry number or the first entry number in the range to
be moved. Source2 (optional) is the last entry number in the
range to be moved. If not specified, only the source1 entry
will be moved.
deny | permit Denies or permits access if specified conditions are met.
protocol Specifies an IP protocol for which to deny or permit access.
Valid values and their corresponding protocols are:
• ip - Any Internet protocol
• icmp - Internet Control Message Protocol
• udp - User Datagram Protocol
• tcp - Transmission Protocol
source Specifies the network or host from which the packet will be
sent. Valid options for expressing source are:
• IP address or range of addresses (A.B.C.D)
• any - Any source host
• host source - IP address of a single source host
source-wildcard (Optional) Specifies the bits to ignore in the source address.