Specifications

Security Configuration Command Set
Configuring Access Lists
14-102 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
14.3.7.2 access-list (standard)
Use this command to define a standard IP access list by number when operating in router mode.
Restrictions defined by an access list are applied by using the
ip access-group command
(Section 14.3.7.4).
access-list access-list-number [insert | replace entry] | [move destination source1
[source2]] {deny | permit} source [source-wildcard]
To insert or replace an ACL entry:
access-list access-list-number insert | replace entry
To move entries within an ACL:
access-list access-list-number move destination source1 [source2]
Syntax Description
ROUTER: This command can be executed when the device is in router mode only. For
details on how to enable router configuration modes, refer to Section 3.3.3.
NOTE: Valid access-list-numbers for standard ACLs are 1 to 99. For extended ACLs,
valid values are 100 to 199.
access-list-
number
Specifies a standard access list number. Valid values are
from 1 to 99.
insert | replace
entry
(Optional) Inserts this new entry before a specified entry in
an existing ACL, or replaces a specified entry with this new
entry.