Specifications

IP Configuration Command Set
Configuring Routing Interface Settings
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 12-3
Purpose
To enable routing interface configuration mode on the device, to create VLAN or loopback routing
interfaces, to review the usability status of interfaces configured for IP, to set IP addresses for
interfaces, and to enable interfaces for IP routing at device startup.
Commands
The commands needed to review and configure interface settings are listed below and described in
the associated section as shown:
• show interface
• interface (Section 12.2.1.2)
• show ip interface (Section 12.2.1.3)
• ip address (Section 12.2.1.4)
• no shutdown (Section 12.2.1.5)