Specifications

Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
11-94 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
11.2.6.8 set cep detection protocol
Use this command to specify an IP protocol type for H.323 or Siemens convergence end points
detection. If an IP address is not set for a phone detection group as described in Section 11.2.6.7,
this will configure detection on UDP and/or TCP ports using a port range defined with the set cep
detection porthigh | portlow command as described in Section 11.2.6.9.
set cep detection detection-id protocol {tcp | udp | both | none}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable both TCP and UDP convergence end points detection for CEP
detection group 1
:
NOTE: This command applies only to Siemens and H.323 phone detection. Cisco
detection uses CiscoDP as its discovery method.
detection-id Specifies a CEP discovery group ID. This group must be
created and enabled using the set cep detection command
as described in Section 11.2.6.5. Valid values are 1 -
2147483647.
tcp | udp | both |
none
Sets the CEP IP protocol type as:
• TCP
• UDP
• Both UDP and TCP
• None
Matrix>set cep detection 1 protocol both