Specifications

Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
11-92 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
11.2.6.6 set cep detection type
Use this command to specify whether a phone detection group will use H.323 or Siemens as its
phone discovery type.
set cep detection detection-id type {h323 | siemens}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the phone detection type to H.323 for CEP group 1
:
NOTE: This command applies only to Siemens and H.323 phone detection. Cisco
detection uses CiscoDP as its discovery method.
detection-id Specifies a CEP discovery group ID. This group must be
created and enabled using the set cep detection command
as described in Section 11.2.6.5. Valid values are 1 -
2147483647.
h323 | siemens Specifies the phone type to detect as H.323 or Siemens.
Matrix>set cep detection 1 type h323