Specifications

Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-91
11.2.6.5 set cep detection
Use this command to create a new H.323 or Siemens phone detection configuration group, or
enable, disable or remove an existing group.
set cep detection detection-id {create | delete | disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create CEP detection group 1
:
NOTE: This command applies only to Siemens and H.323 phone detection. Cisco
detection uses CiscoDP as its discovery method.
detection-id Specifies a CEP discovery group ID. Valid values are 1 -
2147483647.
create | delete |
disable | enable
Creates a new convergence end points detection
configuration group, or removes, disables or enables an
existing group. A group must first be created then enabled
to become operational.
Matrix>set cep detection 1 create