Specifications

Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
11-90 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
11.2.6.4 set cep policy
Use this command to set a global default policy for a CEP detection type. This is the policy that will
be applied when a phone of the specified type is detected on a port. It must be configured using the
policy management commands described in Chapter 11.
set cep policy {cisco | h323 | siemens} profile-id
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to assign policy profile 1 to all H.323 phones detected
:
cisco | h323 |
siemens
Specifies the default policy as Cisco, H.323 or Siemens
phone detection.
profile-id Specifies an ID for this CEP policy profile. This must be
configured using the policy management commands
described in Chapter 11. Valid values are 1 - 65535.
Matrix>set cep policy h323 1