Specifications

Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
11-86 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Purpose
To review, set the status and configure CEP phone detection.
Commands
Commands to configure CEP phone detection are listed below and described in the associated
section as shown.
• show cep (Section 11.2.6.1)
• set cep (Section 11.2.6.2)
• set cep port (Section 11.2.6.3)
• set cep policy (Section 11.2.6.4)
• set cep detection (Section 11.2.6.5)
• set cep detection type (Section 11.2.6.6)
• set cep detection address (Section 11.2.6.7)
• set cep detection protocol (Section 11.2.6.8)
• set cep detection porthigh (Section 11.2.6.9)
• set cep initialize (Section 11.2.6.10)
• clear cep (Section 11.2.6.11)